12 / 24V Universal AAA, AA, C, D and 9V Charger
AUD$524.00

	12V Automatic Bilge Pump Controller
AUD$214.00 Bilge Pump Controller with Probe & built in Alarms 12VDC. Keeps track of how many times activated.

	12V Automatic Dual Bilge Pump Controller
AUD$264.00 Intelligent Pump Controller with Probe & Alarm 12 VDC. Dual pumps for redundancy. Keeps track of number of activations.

	16 Amp Light Dimmer & Motor Speed Controller
AUD$187.00 Intelligent Dimmer / Controller with Instant On / Off. Night/Day light sensor optionally available.

	20 Amp 12VDC Automatic Charge Controller
AUD$250.00 Sophisticated Charge Controller. Three LEDs. For wet or gel Bat. Adjustable output. 20 amps.

	24V Automatic Bilge Pump Controller
AUD$264.00 Bilge Pump Controller with Probe & built in Alarms 24VDC. Keeps track of how many times activated.

	24V Automatic Dual Bilge Pump Controller
AUD$308.00 Intelligent Pump Controller with Probe & Alarm 24 VDC. Dual pumps for redundancy. Keeps track of number of activations.

	3 Bank Digital Voltmeter & Alarm
AUD$209.00 Monitor up to Three Banks- Individual Settable Alarms- NMEA 0183 data output.

	3 BankVolts / Amps / Amp-Hour Monitor with 450A Shunt
AUD$473.00 As Above plus monitors up to Three Banks. 450 amp shunt. NMEA 0183 data output.

	4 Channel NMEA to RS-232 Convertor / Combiner
AUD$369.00 Connect multiple Gauges (or other NMEA instruments) to a Computer's serial input port.

	6 Amp 12VDC PWM Charge Regulator
AUD$107.00 (Pulse Width Modulated) Low cost. Ensures fully charged battery at all times.

	6 Amp 24VDC PWM Charge Regulator
AUD$132.00 (Pulse Width Modulated) Low cost. Ensures fully charged battery at all times.

	8 Amp 12VDC Automatic Charge Controller
AUD$154.00 Sophisticated Charge Controller. Three LEDs. For wet or gel Bat. Adjustable output. 8 amps.

	8 Amp Light Dimmer & Motor Speed Controller
AUD$154.00 Intelligent Dimmer / Controller with Instant On / Off. Night/Day light sensor optionally available.

	8 Amp, Three Stage PWM Charge Regulator with Automatic Low Voltage Load Disconnect
AUD$198.00 (Pulse Width Modulated) Low cost. Ensures fully charged battery at all times. LED indicators. Automatic load disconnect if Battery voltage drops too low. Three Stage voltage regulator (Bulk- Absorption- Float)

	8 Channel NMEA to RS-232 Convertor / Combiner
AUD$524.00 Connect multiple Gauges (or other NMEA instruments) to a Computer's serial input port.

	AC / Volts / Amps / Frequency / kW Monitor / with Sensors
AUD$473.00 Multi-Featured - AC Volts- Amps- Frequency- Kilowatts. High and low AC/Volt/Frequency alarms- can also disable generator.can also disable Generator.

	Bilge Water Alarm
AUD$154.00 Runs for 2 years on 9V alkaline battery. 85db Alarm. Electronic Float.

	Clock / Watch / Race Timer & Alarm
AUD$176.00 Intelligent 12/24 Clock- Watch/Countdown timers with 8 built in alarms. NMEA 0183 Data output.

	DSP Depth Sounder 1000 feet
AUD$385.00 The D110 Digital DSP depth sounder uses Digital Signal Processing (DSP) to reliably display water depth from 1.2 foot (0.4 Metre) to 1000+ feet (365 Metres).

	Depth Sounder with Keel offset & Alarms
AUD$214.00

	Digital 1200deg C Pyrometer with Memory & Alarms with k type Thermocouple
AUD$375.00 Low Cost Pyrometer -20 deg C to 1100 deg C. Complete with K-type thermocouple. NMEA 0183 data output.

	Digital AC Volts Amps Frequency kW Monitor
AUD$539.00 The VAF110 Digital AC Monitor provides accurate digital instrumentation for AC volts, amps, frequency and kW. The VAF110 displays ac voltage from 90 to 300 VAC RMS, AC current from 0 to 150 amps, AC frequency from 30 to 100 Hz and computes volt-amps (kW) from 0.0 to 45.0 kW.

	Digital Clock with 4 Timed Switches (12 Amp total)
AUD$140.00

	Digital Fuel Gauge / Consumption Calculator / with Alarm
AUD$308.00 Clever Fuel Gauge Learns Tank. Displays Gallons / Litres or % plus consumption rate- with Alarm. NMEA 0183 output. Very accurate.

	Digital Fuel Guage
AUD$198.00 Low cost Digital Fuel Gauge. High/Low alarms- works with all standard American and European fuel senders. NMEA 0183 serial data output.

	Digital Oil Pressure Gauge with Alarm
AUD$187.00 Unique- Low and High Pressure Alarms. NMEA 0183 Data Output.Preprogrammed for popular senders from VDO- Teleflex- Faria- etc.

	Digital RPM Engine Hours & Elapsed Time Gauge with NMEA 0183 output
AUD$429.00 The CruzPro RH110 Digital RPM/Engine Hours/Elapsed Time gauge is a four digit digital display of engine RPM, total engine hours, elapsed trip time and maximum r.p.m. seen.

	Digital Rudder Angle Indicator with built-in alarms
AUD$418.00 The AM-30 provides an accurate single sensor rudder angle indicator.

	Digital Speed Temperature Log with NMEA 0183 output
AUD$319.00 Our "CruzPro" range of instruments are intelligent displays that can adapt to any range of previously installed "sending units."

	Digital Three Bank Volts Amps Amp-Hour Monitor
AUD$495.00 The VAH110 Digital Battery Monitor provides accurate low cost digital instrumentation for three banks of batteries between 9.50 and 33.00 Volts. The VAH110 displays battery voltage for three banks and charging or discharge current and tells you how much battery capacity has been consumed and how much is remaining in your main house bank.

	Digital Voltmeter & Alarm
AUD$187.00 Settable High and Low Voltage Alarms. NMEA 0183 serial data output.

	Dual Sender Buffer
AUD$0.00 The SB2 is a sender buffer for two senders that enable the end-user to add a CruzPro digital gauge to their existing analog gauge setup without having to add a new sender or replacing their existing single station sender.

	Engine / Exhaust Temperature Monitor / Alarm with Probe
AUD$176.00 Low Cost Protection for Engine and Exhaust. User settable alarm temperature.

	External Relay Switch
AUD$0.00 The ER1 is an external relay switch with both normally open and normally closed relay contacts that can be activated by the "external alarm output" available on many CruzPro instruments.

	Intelligent NMEA 0183 Remote Data Repeater
AUD$319.00 Monitors up to Four separate data channels. 210 built-in NMEA sentences pre-programmed. Learns new sentences from IBM PC.

	Intelligent Windlass Controller
AUD$524.00 Intelligent- tells you how much chain is out- slows windlass NMEA 0183 etc.

	LPG / Gasoline / Petrol / Vapor Detector & solenoid control
AUD$407.00 Multi-level sensotivity settings with built in Alarm. Gas solenoid control. Can handle two sensors.

	LPG / Petrol Detector Alarm - Internal Sensor
AUD$154.00 Base Model Gas Detector. 12VDC low current drain (0.12 amps). Self contained gas sensor. For LPG and gasoline / petrol.

	LPG Vapor (Vapour) Detector / Alarm
AUD$219.00 Low Cost No Frills Protection

	Multi Step Smart Alternator Regulator
AUD$352.00 SAR20 Smart Alternator Regulator The SAR20 Smart Alternator Regulator turbo-charges your charging system by swapping your fixed voltage regulator with a high performance multi-step Smart Alternator Regulator (SAR). Fixed voltage regulators are inexpensive to manufacture but are a poor trade-off between cost and performance for the boat owner. The initial savings are soon offset by the requirement to run the engine longer to achieve the same charge, battery life, noise, heat and smell generated by the engine. A fixed voltage regulator will also overcharge your batteries on longer runs - reducing their life and requiring more frequent top-ups of water. The CruzPro SAR20 enables you to safely fast charge your boat batteries thereby greatly reducing engine run time. Obviously, fewer hours of engine running saves wear and tear, fuel, and leaves more undisturbed time to enjoy cruising. Your neighbors will also appreciate the extra quiet time. The SAR20 is a multi-step charge controller that commands maximum safe output from your alternator while monitoring battery voltage and temperature. The SAR20 will deliver the bulk of the battery charge at maximum alternator output allowing battery voltage to rise until the "absorption voltage" has been reached. The SAR then lowers the alternator output to maintain a constant battery voltage at the absorption point. The absorption voltage is maintained for a period of time dependent upon several factors and then the SAR20 cuts back the battery voltage to a safe "float" voltage. The SAR20 will also enable you to desulfate your battery plates by enabling an "equalization cycle". During equalization the SAR20 slowly raises battery voltage to an equalization level while limiting the charge current to about 4-6% of your battery's amp-hour capacity. This safely dissolves the sulfates that form on the battery plates during discharge and extends battery life. The correct absorption, float and equalization voltages are dependent upon temperature and battery chemistry. The higher the temperature the lower values of absorption, float and equalization voltages that must be used to optimize battery life. For this reason a remote sensor is used by SAR20 to monitor battery temperature and adjust the voltages accordingly. The SAR20 also has some programming switches inside to tell it what type of battery you are using and further adjust the charging voltages accordingly. Your fixed voltage regulator knows nothing about battery temperature and will almost always be charging to the wrong value. During the bulk delivery phase the SAR20 will command the alternator to deliver maximum output continuously until the absorption voltage is reached. While many modern alternators can do so, some alternators are not "hot rated" to deliver full output continuously and can be damaged by excessive heat. For this reason the SAR20 can be told whether your alternator is hot rated or not and will automatically cut back the output of a non hot-rated alternator to a safe level after a while. With today's heavy loads being demanded by the electrical and electronic conveniences found on many boats it's becoming more common for a second alternator to be fitted to the engine. If you're shopping for a SAR, try to find one that has enough grunt to drive a second alternator field winding. Most alternators require about 3-4 amps excitation to their field winding in order to deliver maximum output so the SAR20 is designed to deliver 8 amps, driving up to two high output alternators. Another handy feature of the SAR20 is a trouble-shooting LED that tells you what it's doing. The LED will blink in various combinations to tell you what stage the SAR20 is in (bulk, absorption, float, equalization). The SAR20 can be set for either 12 and 24 volt alternators.

	Multiple Input 105 db Alarm with 8A Light Flasher
AUD$176.00 MultiAlarm with five inputs. Very Loud 105db. Flashes Spreader lights up to 8 amps.

	Precision Digital Sea Water Temperature Gauge.
AUD$198.00 The WTP35 displays sea water temperature from 32.0 deg F (0.0 deg C) to 90.0 deg F. (32.0 deg C) in tenths of a degree. The units of display is easily selected with a removable jumper wire at the back of the instrument. The WTP35 instrument head is factory calibrated but can be user calibrated in the field with small jumpers on the back of the instrument. All set-up and calibration constants are saved to non-volatile memory. The WTP35 has a built-in red backlight for night-time viewing and works on both 12 and 24 VDC systems. The WTP35 is very easy to install, requiring only a 2-1/8" (55mm) hole saw and screwdriver to connect. The WTP35 outputs NMEA 0183 serial data sentences at 4800 BAUD on rear screw terminal pin "C" (see below). In the NMEA 0183 sentence below, *cs is the check sum: Water Temperature: $VWMTW,xx.x,C*cs Where xx.x is the displayed value of temperature in deg. C. This ASCII information can be used to log performance, repeat the display information at a remote location (see www.cruzpro.com/rp30.html ) or for use with the CruzPro SEAviz virtual instrumentation software running under Windows on your computer (see www.cruzpro.com/seaviz.html). If NMEA 0183 serial data is not required, then the output terminal can be programmed as an external alarm output pin. Plastic transom mount and bronze thru-hull temperature transducers with 30 foot (9 M) cables are seperately available for the WTP35.

	Programmable Digital Ammeter
AUD$194.00 Accurate low cost Digital Ammeter- programmable shunt size. NMEA 0183 serial data output.

	RPM / Engine Hour / Elapsed Time with Alarm
AUD$321.00 Accurate Engine RPM Monitor with built in setable Alarms- max RPM meory- engine hours- elapsed trip time. NMEA 0183 data output.

	Security System & Alarm with three sensors
AUD$297.00 Cost Effective Security for your Boat. Includes 2 reed and one pressure sensing switches. Multiple security codes for electricians- brokers etc.

	Speed, Log, Elapsed Time, Race Timer & Water Temperature Gauge (no transducer)
AUD$198.00 Low Cost Trip Computer- with Temperature- and Race elapsed time Timmers. NMEA 0183 data output. Variety of transducers available.

	Tank Level Gauge
AUD$198.00 Low cost Tank Level Gauge. High/Low alarms- works with all standard American and European senders. NMEA 0183 serial data output.

	Tank Level Gauge/Alarm for three Tanks with Alarms
AUD$319.00 Clever very accurate- Tank level Gauge learns three tanks. Displays Gallons / Litres or %. Separate High and Low alarms. NMEA 0183 data output.

	Trainable NMEA 0183 Data Repeater 4 Inch
AUD$0.00 The CruzPro RP110 remote data repeater is capable of displaying over 200 standard and proprietary NMEA 0183 sentences.